Equipment Errata

Equipment Errata

This page is for mods need on released production boards from DLA. Normally the mods are only needed for ver 1.0 of the boards. If you don't see a board listed here then most likely there is none needed.

Freestyle

• First run pcbs marked ver 1.0
• Missing trace for channel 49
• Add wire jumper as shown in the picture below

SSR4

• First run pcbs marked ver 1.0
• Only need for SSR4 with DMX option on it.
• RJ-45 trace issues.
• Cut the 4 traces as shown in the pictures below

Splitter

• First run pcbs marked ver 1.0
• Missing trace for channel 4

   Comment: If you do not add a .3 inch jumper on the forth RS485 then you will have 1 input and

three DMX out instead of four. you can leave it and not populate the forth RS485 chip and socket and use it with 1 in / 3out or you can add the jumper and have 1 in / 4 out.

• Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332