Difference between revisions of "Troubleshooting"
From Holiday Controller
(→I am getting "Access to the port 'COMx' is denied".) |
|||
| Line 8: | Line 8: | ||
** If you have a PIC programmer, you can program it yourself. | ** If you have a PIC programmer, you can program it yourself. | ||
** If you do not have a programmer, check for [[PIC_Programming|someone to help program your PIC]]. | ** If you do not have a programmer, check for [[PIC_Programming|someone to help program your PIC]]. | ||
| + | |||
| + | ---- | ||
| + | |||
| + | ==My Dongle is not getting detected by windows.== | ||
| + | |||
| + | * Check all of your solder joints again. | ||
| + | * There was one report of at least one bad FTDI USB module. | ||
---- | ---- | ||
| Line 13: | Line 20: | ||
==Vixen is hanging when I run a sequence.== | ==Vixen is hanging when I run a sequence.== | ||
| − | Make sure that the DMX option is unchecked under "Add-ins" | + | * Make sure that the DMX option is unchecked under "Add-ins" |
[[Image:Disable_DMX.JPG|center|thumb|240px]] | [[Image:Disable_DMX.JPG|center|thumb|240px]] | ||
| Line 21: | Line 28: | ||
==I am getting "Access to the port 'COMx' is denied".== | ==I am getting "Access to the port 'COMx' is denied".== | ||
| − | *Try changing the com port in windows. | + | * Try changing the com port in windows. |
| Line 27: | Line 34: | ||
| − | *You will need to make matching changes in Vixen. | + | * You will need to make matching changes in Vixen. |
[[Image:Vixen_Dongle_Plugin_Setup_01.JPG|center|thumb|240px]] | [[Image:Vixen_Dongle_Plugin_Setup_01.JPG|center|thumb|240px]] | ||
Revision as of 18:24, 28 August 2009
Contents
My Lynx Dongle is not working.
- Make sure that your PIC is programmed.
- Any PIC that you are using the in the dongle needs to be programmed.
- There have been no parts coops for the Lynx Dongle.
- If you have a PIC programmer, you can program it yourself.
- If you do not have a programmer, check for someone to help program your PIC.
My Dongle is not getting detected by windows.
- Check all of your solder joints again.
- There was one report of at least one bad FTDI USB module.
Vixen is hanging when I run a sequence.
- Make sure that the DMX option is unchecked under "Add-ins"
I am getting "Access to the port 'COMx' is denied".
- Try changing the com port in windows.
- You will need to make matching changes in Vixen.
