Difference between revisions of "Equipment Errata"
From Holiday Controller
KeithTarpley (Talk | contribs) |
m (Reverted edits by DouglasBarnett (Talk); changed back to last version by Vairmoose) |
||
| (12 intermediate revisions by 5 users not shown) | |||
| Line 17: | Line 17: | ||
==Splitter== | ==Splitter== | ||
* First run pcbs marked ver 1.0 | * First run pcbs marked ver 1.0 | ||
| − | * Missing trace for channel 4 | + | * Missing trace for channel 4 |
| − | * Add wire jumper as shown | + | A jumper on the forth RS485 (channel 4) is necessary to enable 1 in / 4 out operation. Without the jumper, only three of the outputs are active. |
| + | * Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332 | ||
| − | + | [[Category:Hardware]] | |
| + | [[Category:Equipment]] | ||
| + | [[Category:Errata]] | ||
Latest revision as of 10:48, 18 January 2013
This page is for mods need on released production boards from DLA. Normally the mods are only needed for ver 1.0 of the boards. If you don't see a board listed here then most likely there is none needed.
Freestyle[edit]
- First run pcbs marked ver 1.0
- Missing trace for channel 49
- Add wire jumper as shown in the picture below
SSR4[edit]
- First run pcbs marked ver 1.0
- Only need for SSR4 with DMX option on it.
- RJ-45 trace issues.
- Cut the 4 traces as shown in the pictures below
Splitter[edit]
- First run pcbs marked ver 1.0
- Missing trace for channel 4
A jumper on the forth RS485 (channel 4) is necessary to enable 1 in / 4 out operation. Without the jumper, only three of the outputs are active.
- Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332
